Toshiba 42XV540U Owner's Manual - English - Page 36

Chapter 5: Setting up your TV Configuring the input source for the ANT/CABLE terminal To configure the ANT/CABLE input source: 1 Press Y and open the Setup menu. 2 Highlight Installation and press T. A new set of Installation menu icons will appear, as shown below. Setup Installation REGZA-LINK Setup Sleep Timer HDMI Settings PC Settings Power-On Mode Demo Mode Power-Saving Off 3 Open the Terrestrial menu, highlight Input Configuration, and press T. Installation Terrestrial Input Configuration Channel Program Channel Add/Delete Channel Tuning Mode Signal Meter Auto 4 Press B and C c to select the input source (Cable or Antenna) for the ANT/CABLE input on the TV. Input Configuration ANT/CABLE In Cancel Cable Done 5 To save your new settings, highlight Done and press T. To revert to your original settings, highlight Cancel and press T. Programming channels into the TV's channel memory When you press < or , on the remote control or TV control panel, your TV will stop only on the channels you programmed into the TV's channel memory. Follow the steps below to program channels into the TV's channel memory. Programming channels automatically Your TV can automatically detect all active channels in your area and store them in its memory. After the channels are programmed automatically, you can manually add or erase individual channels in the channel memory. Note: • If the ANT/CABLE input signal type is set to Cable, the automatic channel programming process erases channels that were previously programmed into the TV's memory. • If the ANT/CABLE input signal type is set to Antenna, the automatic channel programming process adds newly found channels to the existing set of programmed channels (and does NOT erase channels that were previously programmed into the TV's memory.) To remove an Antenna source channel from the memory, you must manually delete it. • To tune the TV to a channel not programmed in the channel memory, you must use the Channel Number buttons on the remote control. • Programming channels when the ANT/CABLE input is configured for Cable will take substantially longer than when the ANT/CABLE input is configured for Antenna. This is normal; however, once channel programming is finished, you should not have to repeat the programming process again unless your Cable TV service lineup changes significantly. To program channels automatically: 1 You must configure the ANT/CABLE input source, if you have not already done so (- page 36). 2 From the Setup menu, highlight Installation and press T. A new set of Installation menu icons will appear. 36