Toshiba 43AX60 Owners Manual - Page 15

Verifying the device code (990) Use this feature to verify the codes for your other devices. The number of blinks after pressing the 1, 2, 3, and 4 buttons is the 4-digit code set up for that mode. Example: To verify the VCR code is 0385: 1. Press MODE to select the VCR mode. 2. While holding down the RECALL button, press 9, 9, 0 in sequence. 3. Press 1 ➝ 0 blinks. 4. Press 2 ➝ 3 blinks. 5. Press 3 ➝ 8 blinks. 6. Press 4 ➝ 5 blinks. You can verify that the device code of the VCR mode is "0385." Using the Volume Lock feature (993) For the TV, CABLE/SAT, VCR, and DVD modes, the volume controls (VOL yz and MUTE) can be programmed or locked to the selected device mode. This feature does not apply to the AUDIO1/2 modes. Example: To lock the volume controls to always jump to the CABLE/ SAT mode: 1. Press MODE to select the CABLE/SAT mode. 2. While holding down the RECALL button, press 9, 9, 3 in sequence. 3. Press VOL y. The Mode indicator will blink two times (locked). The following table describes in more detail the Volume Lock implementation. Volume Locked to TV CBL/SAT VCR DVD AUD1 AUD2 TV (default) TV TV TV TV AUD1 AUD2 CBL/SAT CBL/SAT CBL/SAT CBL/SAT CBL/SAT AUD1 AUD2 VCR VCR VCR VCR VCR AUD1 AUD2 DVD DVD DVD DVD DVD AUD1 AUD2 AUD1 AUD1 AUD1 AUD1 AUD1 AUD1 AUD1 AUD2 AUD2 AUD2 AUD2 AUD2 AUD2 AUD2 To reset the volume controls to the original device code: 1. Pressing the RECALL button, press 9, 9, 3 in sequence. 2. Press VOL z. The Mode indicator will blink four times (unlocked). Operational feature Reset (980) This feature clears all setup features not related to "Device code set up" and resets the Volume Lock to "TV." To reset the features: While holding down the RECALL button, press 9, 8, 0 in order. The Mode indicator will blink two times, then pause and blink two more times. Number MODE VOL y z RECALL 15 Index Appendix Using the TV's Features Setting up your TV Using the Remote Control Connecting your TV Introduction