Toshiba 43HX71 Owners Manual - Page 24
Adding Channels to the TV's Memory, Programming Now
View all Toshiba 43HX71 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Introduction Connecting your TV Using the Remote Control Adding channels to the TV's memory When you press Channel y or z, your TV will stop only on the channels stored in the TV's channel memory. Follow the steps below and on the next page to program all active channels into the TV's memory. Programming channels automatically Your TV can automatically detect all active channels in your area and store them in its memory. After the channels are stored automatically, you can manually add or erase individual channels (see page 25). To program channels automatically: 1. Press MENU, and then press x or • until the SET UP menu appears. 2. Press y or z until TV/CABLE is highlighted. 3. Press x or • to highlight either TV or CABLE, depending on which you use. If you use an antenna, highlight TV; if you use cable, highlight CABLE. Note: To tune the TV to a channel not programmed in the channel memory, you must use the Channel Number buttons on the remote control. SET UP LANGUAGE CLOCK SET ANT 1 / 2 TV / CABLE CH PROGRAM ADD / ERASE ENGL I SH 00:00 ANT1 TV / CABLE ADD 4. Press z to select CH PROGRAM. MENU yzx • Channel yz SET UP LANGUAGE CLOCK SET ANT 1 / 2 TV / CABLE CH PROGRAM ADD / ERASE ENGL I SH 00:00 ANT1 CABLE ADD 5. Press x or • to start channel programming. The TV will automatically cycle through all the TV or Cable channels (depending on which you selected), and store all active channels in the channel memory. While the TV is cycling through the channels, the message "Programming Now-Please Wait" appears. 6. When channel programming is complete,the message "Completed" appears. 7. Press Channel y or z to view the programmed channels. Setting up your TV Using the TV's Features Appendix Index 24