Toshiba 50HP81 Owners Manual - Page 16
PC Input
View all Toshiba 50HP81 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
Connections PC Input connection COMPUTER AUDIO PC IN POWER / R - STANDBY G POWER ON INPUT - VOL + Gender changer (if necessary) RGB PC cable D-sub 15p Ferrite core (supplied) Audio Less than 7 7/8" (20 cm) 1/8" (3mm) stereo plug Connect a cable which matches the audio output port on the computer. Notes: (1) Computer signals which can be input are those with a horizontal scanning frequency of 15.5 to 110 kHz and vertical scanning frequency of 48 to 120 Hz. (However, signals exceeding 1200 lines may not be displayed properly.) (2) The signal resolution is a maximum of 1024 × 768 dots when the aspect mode is set to "NORMAL", and 1366 × 768 dots when the aspect mode is set to "FULL". If the signal resolution exceeds these maximums, it may not be possible to show fine detail with sufficient clarity. (3) The PC input terminals are DDC1/2B-compatible. If the computer being connected is not DDC1/2B-compatible, you will need to make setting changes to the computer at the time of connection. (4) Some PC models cannot be connected to the set. (5) There is no need to use an adapter for computers with an MS-DOS 5 (or greater) compatible D-sub 15P port. (6) The computer shown in the illustration is for example purposes only. (7) Additional equipment and cables shown are not supplied with this set. (8) Do not set the horizontal and vertical scanning frequencies on the PC for PC signals which are above or below the specified frequency range. Signal Names for D-sub 15P Connector 11 12 13 14 15 6 7 8 9 10 12345 Pin layout for PC input terminal Pin No. 1 2 3 4 5 Signal Name R G B GND (Ground) GND (Ground) Pin No. Signal Name Pin No. 6 GND (Ground) 11 7 GND (Ground) 12 8 GND (Ground) 13 9 NC (not connected) 14 10 GND (Ground) 15 Signal Name GND (Ground) SDA HD/SYNC VD/SYNC SCL 16