Toshiba 50M2U User Guide - Page 48
Setup, Installation, ENTER
View all Toshiba 50M2U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
48 Setting up your TV Storing channels in memory (optional) NOTE ❖ You must set up the ANT/CABLE input source before programming channels. See "ANT/CABLE IN" on page 46. ❖ The automatic channel programming process will erase channels that were previously programmed into the TV's memory. ❖ To tune the TV to a channel not programmed in the channel memory, you must use the Channel Number buttons on the remote control. ❖ Programming channels when the ANT/CABLE input is configured for Cable will take substantially longer than when the antenna input is configured for Antenna. This is normal; however, once channel programming is finished, you should not have to repeat the programming process again unless your Cable TV service lineup changes significantly. To program channels automatically: 1 Configure the antenna input source, if you have not already done so, see "ANT/CABLE IN" on page 46. 2 Press the MENU button and open the Setup menu. 3 Highlight Installation, and then press the ENTER button. (Sample Illustration) Setup menu - Installation selection