Toshiba 55A60 Owners Manual - Page 12

Introduction Connecting your TV Using the Remote Control To control a cable TV converter: Program the remote control to recognize the brand of your converter. The shaded buttons shown on the right will control the cable TV converter. Set the TV/CABLE/VCR switch to the CABLE position. Programming the remote control for use with a VCR or a cable TV converter This remote control is pre-programmed to operate Toshiba VCRs. To use VCRs or cable converters other than Toshiba models, you must follow the steps below before you operate your remote control. 1. Refer to the VCR and Cable TV converter code tables on pages 13-14 to find the corresponding code for your VCR or converter. If more than one code is listed, try each one separately until you find the one that works. 2. If you are reprogramming the remote control to operate your: • VCR, set the TV/CABLE/VCR switch on the remote control to VCR. • Cable converter, set the TV/CABLE/VCR switch on the remote control to CABLE. 3. While holding down RECALL, press the Channel Number buttons (0-9) to enter the code for your brand of VCR or converter. 4. Point the remote control at the VCR or converter and press POWER to test the code. If the VCR or converter responds, you have entered the correct code. If the VCR or converter does not respond to the remote control, you may have entered the wrong code. Repeat steps 1-4 using another code. 5. To control the TV, set the TV/CABLE/VCR switch to TV. LIGHT RECALL POWER TV CABLE VCR MUTE TV/VIDEO TIMER 123 CH 456 7 100 C.CAPT 89 CH RTN VOL 0 ENT ADV/ PIP CH MENU FAV ENTER FAV RESET ADV/ EXIT PIP CH RECALL POWER TV/CABLE/ VCR Switch Channel yz Channel Numbers Enter Note: Every time you replace the batteries, you must reprogram the remote control. Some newer VCRs are capable of working on either of two remote codes. These VCRs have a switch labeled "VCR1/VCR2." If your VCR has this kind of switch and does not respond to any of the codes for your VCR brand, set the switch to the other position (VCR1 or VCR2) and reprogram the remote control. For future reference, write down the codes you used: VCR code Cable TV converter code Setting up your TV Using the TV's Features Appendix Index 12