Toshiba 70CT Memory Installation Guide - Page 1

Viking Memory INSTALLATION GUIDE TOSHIBA® Libretto 50CT & 70CT 6. Locate the holding screw at the top left corner of the open compartment. Remove this screw with a small Phillips head screwdriver. 7. To install the memory module, align the connector on the module with the connector in the system's expansion slot. Firmly press down directly over the connector on the module until it's well seated in the slot. Do not force the module into position. The module can only be placed in the expansion slot one way due to the position of the connector. Manual No. 1005205 • Release 12/97, Rev. B SPEED POWER PERFORMANCE The Toshiba Libretto 50CT and 70CT come standard with 16MB memory soldered. They can be expanded to a maximum of 32MB by installing the following Viking Components memory options into their one available expansion slot. Description Viking P/N 8MB Memory Module 16MB Memory Module T2055, RT2055 T2056, RT2056 Caution: Electro Static Discharge (ESD) can damage electronic components. Before touching the memory module, ensure that you are discharged of static electricity by touching a grounded metal object. INSTALLATION INSTRUCTIONS: 1. Turn the computer off and disconnect the AC power supply and any other cables from the unit. Note: If the unit appears to be powered down, ensure that it is not in Suspend mode. 2. Turn the computer upside-down. Remove the battery from the system. If you are not familiar with this procedure, please refer to your computer's "Owner's Manual." 3. Return the system right-side up and open the display screen. 4. Locate the keyboard retaining strip at the base of the display screen. With your finger nail, lift the strip up by its right edge and completely remove it. 5. Locate the holding screw in the area where you have just removed the retaining strip. Remove the screw with a small Phillips head screwdriver. Then lift the keyboard panel by the edge closest to the display screen and rest it upside-down at the base of the system. Caution: Do not disconnect, cut or apply excessive force to the keyboard cable. 8. Replace and secure the holding screw, through the memory module, in the upper right corner of the open compartment. Do not over tighten the holding screw. 9. Replace the keyboard panel to its original position and be sure to secure its holding screw. Then replace the keyboard retaining strip. 10. Replace the battery back into its compartment. 11. Replace the AC power supply and any other cables you may have disconnected. 12. Turn the system on. The computer will automatically reconfigure itself to recognize the newly added memory. The new memory can be verified during the POST routine at startup and at the SETUP utility. The installation is now complete. WARRANTY & DISCLAIMERS: All Viking Components products have been thoroughly tested free of defects in material and workmanship. If any malfunction should occur while using one of our products in its recommended environment, Viking, at its option, will repair or replace the product at no charge, provided the product or any part thereof has not been abused, misused, neglected, replaced, repaired or modified. Viking shall make the final determination as to the existence and the cause of any defect. Viking will not repair or replace products designated as having a "Limited Lifetime" which fail solely because their estimated life has expired. No warranty is made with respect to customer products produced to original purchaser specifications except as specifically stated in writing by Viking. All shipping costs shall be the responsibility of the purchaser. Except as provided herein, there are no express or implied warranties of merchantability or fitness for a particular purpose. Under no circumstances will Viking Components be liable in any way to the purchaser for any damages, including but not limited to lost revenue, lost wages, or any other incidental or consequential damages arising out of the use of or inability to use this product. Viking reserves the right to make modifications in both hardware and software without prior notifications. All Viking Components are 100% guaranteed compatible with the OEM machines for which they are designed. All OEM's names, trademarks and part numbers are used for identification purposes only, and in no way imply that any of our products are original equipment parts. Toshiba and Libretto are a registered trademarks of Toshiba Corporation.