Toshiba A500 PSAR9C-01V002 Users Manual Canada; English - Page 106
Points to note about the Fingerprint Sensor
View all Toshiba A500 PSAR9C-01V002 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 106 highlights
Operating Basics Figure 4-2 Slide the finger over the recognition sensor ■ Avoid swiping with the finger stiff or pressed-on too hard: Fingerprint reading may fail if the center of the fingerprint is not touching on the sensor, or when finger is swiped while pressing hard. Make sure that the center of the fingerprint is touching the sensor before swiping. ■ Confirm the center of the fingerprint whirl before swiping: The thumb's fingerprint has a bigger whirl, which is prone to misalignment and distortions. This will cause difficulty in registration and a drop in the authentication success rate. Always confirm the center of the fingerprint whirl so that it is swiped along the centerline of the sensor. ■ When fingerprint reading is not successful: There is a possibility of authentication failures if the finger is swiped too quickly or too slowly. Follow the onscreen instructions to adjust the speed of the swipe. Points to note about the Fingerprint Sensor Failure to follow these guidelines might result in (1) damage to the sensor or cause sensor failure, (2) finger recognition problems, or lower finger recognition success rate. ■ Do not scratch or poke the sensor with your nails or any hard or sharp objects. ■ Do not press the sensor strongly. ■ Do not touch the sensor with a wet finger or any wet objects - keep the sensor surface dry and free from water vapor. ■ Do not touch the sensor with a soiled or dirty finger as minute foreign particles of dust and dirt may scratch it. ■ Do not paste stickers or write on the sensor. ■ Do not touch the sensor with a finger or any other object which may have a build-up of static electricity on it. Observe the following before you place your finger on the sensor whether for fingerprint enrollment/registration or recognition. User's Manual 4-4