Toshiba D-VR610KU Owners Manual - Page 119
There is no sound or the sound is
View all Toshiba D-VR610KU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 119 highlights
TROUBLESHOOTING Symptom The subtitle language cannot be changed or turned off. The angles cannot be changed. Recording does not stop immediately after you press [STOP C]. The disc tray does not open when you press [OPEN/CLOSE A]. "Repairing" appears on the TV screen. Repairing 88% In a case you intend to cancel the repairing process. D V Do you want to cancel a repairing process ? When selecting "Yes", D the disc may not be usable. Yes No Remedy • Multilingual subtitle are not recorded on the DVD-video. • Multi-angles are not recorded on the DVD-video being played back. • The angle-change operation is whenever possible as long as the disc contains a multi-angle portion. Actual change will be performed when the portion has come up. • The DVD-video prohibits changing angles. • Try changing the angle using the DVD-video's menu. • It may take a few seconds for the unit to input disc data before recording stops. • It may take a few seconds for the disc tray to open after you have recorded or edited a disc. This is because the unit is adding disc data to the disc. • If there is a power failure or unplugging during recording, finalizing, formatting or editing (even after "Repairing" disappears), a repairing process will begin automatically just after turning the unit on again. It may take several minutes up to about several hours. • If you intend to cancel the repairing process, press [AOPEN/CLOSE] on the front panel, then select "Yes" and press [ENTER]. After that, press [OPEN/CLOSE A] to take out the disc. The disc canceled during the repairing process MAY NOT work. Repairing 88% No image from HDMI connection. There is no sound or the sound is distorted. • Check the HDMI connection. (Check the status of the HDMI related indications.) • Check whether the connected monitor device or other device supports HDCP. (This unit will not output a video signal unless the other device supports HDCP.) • Check the setting of HDMI. • Check whether the output format of this unit (HDMI FORMAT) matches the supported input format of other connected device. • If the unit is connected to the unauthorized display device with an HDMI cable, the audio/video signal may not be output when playing back a commercial DVD-video. • The HDMI sound is not output when "HDMI Audio" is set to "OFF". • Check the RCA audio cable connection. If you are using HDMI-DVI conversion cable, you must connect the RCA audio cable, too. • Check whether the output format of this unit (HDMI FORMAT) matches the supported input format of other connected device. There is no picture. • If you connect the cable to S-VIDEO OUT/ COMPONENT VIDEO OUT / HDMI OUT jack, try connecting it to AUDIO / VIDEO OUT jack instead. Picture noise appears. • Head cleaning for VCR may be necessary. Refer to "Auto Head Cleaning" (page 5). • Adjust tracking control for better picture by pressing [TRACKING / ] V while you are playing back a cassette tape. C The cassette tape does not play back. • No cassette tape is inserted. R The tape ejected after you press [REC I]. • Make sure the cassette tape has an erase-protection tab when you record to a cassette tape. If needed, cover the hole with cellophane tape. The remote control does not function. • Check if a cassette tape is in this unit. The motor rotates even when playback / recording is stopped. • The motor may rotate for the duration of approximately 5 minutes for efficient operation. This is not a malfunction. 104 EN E9KGAUD_D-VR610KU_EN.indd 104 2007/12/18 17:11:36