Toshiba DF02A Instruction Manual - Page 6
Part Names And Functions
UPC - 032017719804
View all Toshiba DF02A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
3. PART NAMES AND FUNCTIONS Pan ADJ Screw Turn the ring-type screw to adjust the lens pan angle. Fasten and lock it after completing the adjustment. Horizontal ADJ Ring Turn the ring to adjust the horizontal angle of image. Power Input Wire Connect the power cable to 24V AC or 12V DC. Length: approx. 12 inches (300mm) Video Wire (BNC Tap) Connect the video cable to a monitor or video device. The image is outputted when powered on. Length: approx. 12 inches (300mm) Lens Iris ADJ Use to compensate for the iris level. Turn toward L (low) for a darker picture. Turn toward H (high) for a brighter picture. Optimum value is adjusted at the default setting. V Phase ADJ Adjust the phase difference between this camera and other cameras in Line Lock mode. Mode Setting Switch 1234 ON OFF 1: BLC (Backlight Compensation Control) When switched on, it automatically adjusts to compensate for subjects that are lit from behind. 2: AGC (Auto Gain Control) When switched on, it automatically adjusts the image in relation to the brightness of the subject. 3: DC/AES Not available for this camera. Be sure to switch to ON. 4: LL (Line Lock) When switched on, its function is activated. Line Lock is available with 24V AC only. Tilt ADJ Screws Turn the screws to adjust the lens tilt angle. Fasten and lock them after completing the adjustment. MON (Monitor Out) When installing the camera, it is available to check the image with monitor out harness wire. Downloaded from www.Manualslib.com manuals search engine - 5 -