Toshiba DR430 Owners Manual - Page 95

Introduction Connections Basic Setup Disc Management Recording TROUBLESHOOTING Symptom HDMI No image from HDMI connection. There is no sound or the sound is distorted. Others The unit does not operate properly. The disc tray does not open when you press [OPEN/CLOSE A]. "Repairing" appears on the TV screen. Repairing Remedy • Check the HDMI connection. (Check the status of the HDMI related indications.) • Check whether the connected monitor device or other device supports HDCP. (This unit will not output a video signal unless the other device supports HDCP.) • Check the setting of HDMI. • Check whether the output format of this unit (HDMI FORMAT) matches the supported input format of other connected device. • If the unit is connected to the unauthorized display device with an HDMI cable, the audio/video signal may not be output when playing back a commercial DVD-video. • The HDMI sound is not output when "HDMI Audio" is set to "OFF". • Check the RCA audio cable connection. If you are using HDMI-DVI conversion cable, you must connect the RCA audio cable, too. • Check whether the output format of this unit (HDMI FORMAT) matches the supported input format of other connected device. • When static electricity, etc., causes the unit to operate abnormally, unplug the unit and then plug it in again. • It may take a few seconds for the disc tray to open after you have recorded or edited a disc. This is because the unit is adding disc data to the disc. • If there is a power failure or unplugging during recording, finalizing, formatting or editing (even after "Repairing" disappears), a repairing process will begin automatically just after turning the unit on again. It may take several minutes up to about several hours. In case you intend to cancel the repairing process. Do you want to cancel a repairing process ? When selecting "Yes", the disc may not be usable. Yes No Repairing • If you intend to cancel the repairing process, press [AOPEN/CLOSE] on the front panel, then select "Yes" and press [ENTER]. After that, press [OPEN/CLOSE A] to take out the disc. The disc canceled during the repairing process MAY NOT work. Error message Disc Error - Please eject the disc. - Playback feature may not be available on this disc. Unknown USB Device/File - Please Remove the USB. - Insert a compatible USB device. Region Error - Please eject the disc. - Playback is not authorized in your region. Parental Lock On The current selected parental level prohibits playback. Recording Error This program is not allowed to be recorded. Recording Error This program is not recordable in Video mode. Recording Error This program is not recordable in +VR mode. Cause • Unplayable disc is inserted in the unit. • The disc is upside down. • Format of the files in the connected USB device are not supported. • Incompatible USB device is connected. • Playback is not authorized in the region of the DVD-video which you inserted in the unit. • The current selected parental level prohibits playback. • You are trying to record the copy prohibited program. • You are trying to record the copy-once program onto the DVD-RW disc in video mode. • You are trying to record the copy-once program. Solution • Insert the standardized disc which have the marks on pages 9-10. • Insert the disc with the labeled side facing up. • Insert a compatible USB device with supported file format. If this does not solve the problem, use other type of compatible USB device. • Insert the DVD-video with region codes 1 or ALL. • Check "Parental Lock" setting in "Playback" menu (page 84). • You cannot record copy prohibited programs. • Set "Format Mode" to "VR mode" (page 27). • Insert the DVD-RW disc in VR mode (ver.1.1 or 1.2 compatible with CPRM). Playback Editing Function Setup Others &1&"6%@%3,6@&/JOEE


 EN 95