Toshiba G30 PQG32C-AV402E Users Manual Canada; English - Page 196
Installing a memory module
View all Toshiba G30 PQG32C-AV402E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 196 highlights
Optional Devices Use a #0 point Phillips screwdriver to remove and fasten the screws - the use of an incorrect screwdriver can damage the screw heads. Installing a memory module The computer contains slots for two memory modules, one positioned immediately over the other - the procedures are the same for installing either module. 1. Set the computer to Boot Mode and turn its power off - make sure the Power indicator is off (refer to the Turning off the power section in Chapter 3, Getting Started, if required). 2. Remove the AC adaptor and all cables and peripherals connected to the computer. 3. Turn the computer upside down and remove the battery pack (refer to Replacing the battery pack section in Chapter 6, Power, if required). 4. Loosen the screw securing the memory module cover in place - please note that this screw is attached to the cover in order to prevent it from being lost. 5. Slide your fingernail or a thin object under the cover and lift it off. Memory module cover Screw Removing the memory module cover 6. Align the notch of the memory module with that of the memory slot and gently insert the module into the slot at about a 45 degree angle before pressing it down until the latches on either side snap into place. Slot B Slot A 9-14 Seating the memory module User's Manual