Toshiba IK-6420A Specifications - Page 6

10. NOTES ON USE AND INSTALLATION • Do not aim the camera at the sun Never aim the camera at the sun even with the camera power off. • Do not shoot intense light Intense light such as a spotlight may cause a bloom or smear. A vertical stripe may appear on the screen. However, this is not a malfunction. • Treat the camera with care Do not drop the camera or subject it to intense vibration. • Never touch internal parts Do not touch the internal parts of the camera other than the parts specified. • Do not splash water on the camera Install the camera where the camera can be kept dry. If the camera gets wet, turn off the power and contact your dealer. • Keep the camera installation away from video noise If cables are wired near electric lighting wires or a TV set, noise may appear in images. In this event, relocate cables or reinstall equipment. • Check the ambient temperature and humidity Avoid using the camera where the temperature is hotter or colder than the specified operating range. Doing so could affect the internal parts or cause the image quality to deteriorate. Special care is required to use the camera at high temperature and humidity. • Should you notice any trouble If any trouble occurs while you are using the camera, turn off the power and contact your dealer. If you continue to use the camera when there is something wrong with it, the trouble may get much worse and an unpredictable problem may occur. 11. IN CASE OF PROBLEMS Condition No image Unnatural color Check Point Are the camera and connected equipment turned on? Is the iris of the lens adjusted properly? Are cables connected correctly? Is the monitor TV adjusted correctly? Is the lighting too dim? 12. SPECIFICATIONS IK-6210A Power 24V AC ~ ±10% 60Hz / 12V DC ±10% Power consumption 3.5W with Al lens Image sensor 1/3 inch CCD image sensor Image pickup area 0.194 inch (4.92 mm) horizontal x 0.145 inch (3.69 mm) vertical Effective picture element 510 horizontal x 492 vertical Scanning system 2:1 interlace NTSC Standard TV system Scanning frequency 15.75 KHz horizontal 60 Hz vertical Synchronization Line-Lock, Internal manually switchable Resolution 350 Horizontal TV lines Minimum illuminance of subject 0.2 lux (F1.2, More than 10% of image output γ = 0.45) S/N 50 dB or more (weight ON) Video output VBS 1.0 V p-p / 75 ohms, composite Output impedance 75 ohms unbalanced White balance Automatic (2500 K to 10,000 K) Iris control Video Out / Iris Driver Circuit Built in Gain control Average AGC (26 dB) Backlight compensation Manual ON/OFF switching, center zone light measuring system Lens mount CS mount Ambient temperature 14˚F to 122˚F (-10˚C to +50˚C) Ambient humidity 20% to 80% Weight 0.77 lbs (350 g) External dimensions 2.48(W) x 1.97(H) x 4.57(D) inches (63(W) x 50(H) x 116(D) mm) Automatic electronic shutter ON (1/60 s to 1/100000 s) /OFF (1/60 s) 1-6 - 12 - - 13 - IK-6420A