Toshiba PA3927U-1PRP dynadock U3.0 User Guide - Page 22

22 Setting Up the dynadock™ and Connecting Peripherals 2 Plug the other end of the HDMI® cable (not included) into the HDMI® out port on the dynadock™. NOTE The DVI or HDMI® cable provides digital communication between the display and computer, while the VGA cable provides analog communication. If your display has a DVI or HDMI® port, use the DVI cable or HDMI® cable to obtain finer resolution options. NOTE The display cable can be connected/disconnected at any time without disconnecting the dynadock™ from your computer. NOTE If no output is seen on the display connected to the dynadock™, the current video resolution setting may not be supported by the display. This can happen if the display does not report its supported modes to the dynadock's DVI component. Adjust the resolution of the external display until an image appears. For more information, see "Using the TOSHIBA dynadock™ U3.0 Utility" (page 26). You can customize the video settings of the dynadock™. See "Adjusting video settings" on page 28 for more information. Connecting to a network Connect one end of a network cable (not provided) to the Network port (RJ-45) on the dynadock™ and the other end to your network. If the network is not automatically connected, configure the network properties of the Ethernet adaptor as follows: ❖ In Windows® 7, click Start, Control Panel, Network and Sharing Center, and then Change adapter setting. ❖ In Windows Vista®, click Start, Control Panel, View network status and tasks, and then Manage network connections. ❖ In Windows® XP, click Start, Connect to, and then Show all Connections.