Toshiba R400 PPR40C-00H09E Users Manual Canada; English - Page 126
hard disk drive, CD-ROM, FDD, Network LAN, USB Memory boot., Enter
View all Toshiba R400 PPR40C-00H09E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 126 highlights
HW Setup & BIOS Setup To change the boot drive, follow the steps below. 1. Hold down F12 and boot the computer. 2. The following menu will be displayed with the following icons: Built-in hard disk drive, CD-ROM, FDD, Network (LAN), USB Memory boot. Please note that a highlighted bar will only appear under the selected device. 3. Use the left/right cursor keys to highlight the boot device you want and press Enter. ■ If only a Supervisor Password has been set, the following should be noted: ■ The boot device menu will appear when the 'Able to run HW Setup' option has been configured. ■ The boot device menu will not appear when the 'Unable to run HW Setup' option has been configured. ■ If both a Supervisor Password and a User Password are set, the following should be noted: ■ The boot device menu will appear when you use either the Supervisor Password or the User Password to start the computer, and the 'Able to run HW Setup' option has been configured. ■ The boot device menu will not appear when you use the User Password to start the computer and the 'Unable to run HW Setup' option has been configured. ■ The boot device menu will appear when you use the Supervisor Password to start the computer, even if the 'Unable to run HW Setup' option has been configured. The boot device selection methods described above will not change the boot priority settings that have been configured in HW Setup. In addition, if you press a key other than one of those listed, or if the selected device is not installed, the system will continue to boot according to the current and available settings in HW Setup. User's Manual 7-4