Toshiba S10 PTSB3C-MN809C Users Manual Canada; English - Page 77
Installing a memory module, Power
View all Toshiba S10 PTSB3C-MN809C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 77 highlights
TECRA A10/S10/M10/SatellitePro S300 Installing a memory module To install a memory module, follow the steps as detailed below: 1. Shut down the computer - make sure the Power indicator is off (refer to the Turning off the power section in Chapter 1, Getting Started if required). 2. Remove the AC adaptor and all cables and peripherals connected to the computer. 3. Close the display panel. 4. Turn the computer upside down and remove the battery pack (refer to Replacing the battery pack section in Chapter 6, Power and Power-Up Modes, if required). 5. Loosen the one screw securing the memory module cover in place please note that this screw is attached to the cover in order to prevent it from being lost. Use a point size 0 Phillips screwdriver. 6. Slide your fingernail or a thin object under the cover and lift it off. Memory module cover Screw Figure 3-8 Removing the memory module cover 7. Align the notch of the memory module with that of the memory slot and gently insert the module into the slot at about a 45 degree angle before holding it down until the latches on either side snap into place. Notch Slot B Slot A User's Manual Figure 3-9 Seating the memory module 3-25