Toshiba TDP-T90U User Manual - Page 17
Operations
View all Toshiba TDP-T90U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Using the menu (Continued) ■ The default setting menu This menu shows placement status and other settings. Item Projection mode Description Sets projection mode in accordance with Placement Style. p.20 (Standard) (Rear) (Mounted from ceiling) (Rear mounted from ceiling) No signal power off Set the timer to wait for the power to be turned off after signal input stops. Press . Switch with and . Off (not turned off)/1 min./5 min./10 min./30 min./60 min. Auto input Set whether the input with signals is only selected or not. search On Off Power on Sets whether to turn on the power when the ON/STANDBY button is pressed (Manual), or when the power cord is plugged in (Auto). Manual Auto Lamp power [Note 1] Sets the lamp power. Low Standard High Fan mode [Note 2] Sets the cooling fan speed. Standard High Reset all Press . Resets all adjustments and settings to their factory settings. Yes No Notes 1: When Lamp power is set to Low, the screen becomes a little darker, but the cooling fan noise gets quieter. This setting will be cleared when you turn the power off. 2: Setting [Fan mode] to [High] increases the cooling fan speed. Set this option to use the projector, for example, at high altitude (over 1,500 meters above sea level). Notes • Note that in the event of a power outage but the power is restored afterwards, the projector power will come on if Power on is set to Auto, and the power cord is plugged in. • When you turn off the projector even if Power on is set to Auto, you must press the ON/ STANDBY button to turn the power off. ■ Displaying Information (Status display) This displays information about the input signal, lamp use time, etc. "Yes": displayed, "No": not displayed Item Input Mode name H-resolution V-resolution H-frequency V-frequency Sync Signal format Video mode Lamp time Lamp reset count Total time Version Description Computer Y/PB/PR Input source name Yes Yes RGB input mode [Note 1] Yes No Horizontal resolution (in dots) Yes No Vertical resolution (in dots) Yes No Horizontal sync frequency Yes No Vertical sync frequency [Note 2] Yes No Sync signal polarity [Note 3] Yes No Y/PB/PR signal format No Yes Color method of video signal No No Time of lamp use [Note 4] Yes Yes The count for lamp replacement Yes Yes The total time that this projector is used Yes Yes Firmware version [Note 5] Yes Yes Video S-video Yes No No No No No No No Yes Yes Yes Yes Yes Camera Yes No No No No No No No No Yes Yes Yes Yes Notes 1: The mode of supported RGB signals p.45 is shown. 2: Same as the refresh rate of the computer signal. 3: Sync signal polarity shown as P (positive) or N (negative) for [H/V]. 4: Displays [Lamp time] as a measure of when the lamp should be replaced. (Cannot be used as a counter of guaranteed lamp time.) When the displayed time approaches 2,000 hours, consult with a store about getting a TLPLW3 replacement lamp (sold separately) prepared. 5: [Version] shows the version of the projector's internal control program. This version is referred to for customer service, etc. Note • The displayed information will not be refreshed if the status changes. To refresh the information, dismiss the display, then display it again. Operations 32 33