Toshiba TDP-TW355 User Manual - Page 25
Displaying Information (Status display), How to use the PC card slot, Removing a PC card - tlplw14
View all Toshiba TDP-TW355 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Using the menus (Continued) ■ Displaying Information (Status display) This displays information about the input signal, lamp use time, LAN connection status, etc. "Yes": displayed, "No": not displayed Item Description Computer Y/PB/PR Video S-video Wireless/ Card USB memory Projector Input Input source name Yes Yes Yes Yes Yes Mode name RGB input mode [Note 1] Yes No No No No Resolution Resolution (in dots) Yes No No No No Frequency Sync frequency Yes No No No No Sync Sync signal polarity [Note 2] Yes No No No No Signal format Y/PB/PR signal format No Yes No No No Video mode Color method of video signal No No Yes No No Lamp time Time of lamp use [Note 3] Yes Yes Yes Yes Yes Lamp reset count The count for lamp replacement Yes Yes Yes Yes Yes Total time The total time that this projector is used. Yes Yes Yes Yes Yes Version Firmware version [Note 4] Yes Yes Yes Yes Yes Wired LAN Connection status Displays connection status of LAN. Yes Yes Yes Yes Yes IP address Displays the IP address. Yes Yes Yes Yes Yes Subnet mask Displays numeric value of subnet mask. Yes Yes Yes Yes Yes Gateway Displays numeric value of gateway. Yes Yes Yes Yes Yes MAC address Displays MAC address of the projector. [Note 5] Yes Yes Yes Yes Yes PJLink class PJLink version Yes Yes Yes Yes Yes Notes 1: The mode of supported RGB signals p.88 is shown. 2: Sync signal polarity shown as P (positive) or N (negative) for [H/V]. 3: Displays [Lamp time] as a measure of when the lamp should be replaced. (Cannot be used as a counter of guaranteed lamp time.) When the displayed time approaches 2,000 hours, consult with a store about getting a TLPLW14 replacement lamp (sold separately) prepared. 4: [Version] shows the version of the projector's internal control program. This version is referred to for customer service, etc. 5: In case that "------" appears for MAC address, please contact your dealer. Note • The displayed information will not be refreshed if the status changes. To refresh the information, dismiss the display, then display it again. The information regarding wired LAN is refreshed every time it is displayed. 48 How to use the PC card slot The wireless LAN PC card enables you to connect the projector wirelessly with a personal computer that supports IEEE802.11b/g based wireless LAN. p.51 (Please note that communication between all the computers based on IEEE802.11b/g and this projector is not guaranteed.) You can also use a commercially available memory PC card to project JPEG image files using this projector. p.58 Please follow the steps below when removing or mounting a PC card. ■ Mounting a PC card q Remove the slot cover. Press lightly on the circle ("O") while sliding the cover in the direction of the arrow. ■ Removing a PC card q Look at CARD indicator. If it is off, proceed to step r. CARD indicator UNMOUNT button Slot cover w Insert the PC card. After making sure of the card orientation, press it in firmly until it stops. PC Card w Press the UNMOUNT button. Begins processing for PC card removal. e Wait until CARD indicator goes out. Never remove the PC card while lit. Doing so could damage the PC card or corrupt your data. r Press the Eject button. Eject button ■ If CARD indicator turns red Press the RESET switch with a thin pin or similar implement (it is at the bottom of a recess). CARD indicator RESET switch 49 Operations