Toshiba TDP-XP2 User Manual - Page 20
Preparing and using the remote control
View all Toshiba TDP-XP2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Preparing and using the remote control ■ Loading a coin cell battery into the remote control j Remove the battery holder. Hold down the side release firmly and pull out the battery holder. ■ Operating the remote control Point toward the projector's infrared remote sensor, and press a button on the remote control. • Operating the projector from the front k Load a coin cell battery (CR2025). Be sure to align the plus and minus ends of the battery properly. Approx.15 Approx. 7m TS TS CR2302V5OL Notes l Replace the battery holder back into the remote control. M CR2302V5OL • When you use for the first time after purchase, a plastic sheet is provided between the battery and its contact. Be sure to remove by pulling it off. • When operating the remote control from behind the projector, the infrared beam is reflected on the projecting surface and may travel a shorter distance to reach the projector depending on the shape and material of the projecting surface. Coin cell battery • Before using the battery, be sure to observe the Safety Precautions described in previous pages. • Remove the battery from remote control when not using for extended periods. • If the remote control stops working, or if its range decreases, replace the battery with a new one. • Keep the battery away from the reach of children. Battery is choking hazard and can be very dangerous if swallowed. If the battery is swallowed, seek medical assistance immediately. The remote control • The remote control may fail to operate if the infrared remote sensor is exposed to bright sunlight or fluorescent lighting. • Do not drop or bang. • Do not leave in hot or humid locations. • Do not allow it to get wet or place it on top of wet objects. • Do not take apart. • In rare cases, ambient conditions could impede the operation of the remote control. If this happens, point the remote control at the main unit again, and repeat the operation. 20