Toshiba TLP-X4100U Owners Manual - Page 14

CONNECTING PROJECTOR CONNECTING TO COMPUTER Cables used for connection (✽ = Cable or adapter is not supplied with this projector.) • VGA Cable (HDB 15 pin) • USB Cable ✽ • DVI-Digital Cable (for Single Link T.M.D.S.) ✽ • MAC Adapter (When connecting to Macintosh computer) • BNC Cable ✽ • Audio Cables (RCA x 2 and Mini Plug (stereo) x 1) ✽ • Control Cable for PS/2 Port, Serial Port or ADB Port IBM-compatible computer or Macintosh computer (VGA / SVGA / XGA / SXGA) Desktop type Laptop type Monitor Output Monitor Output USB port Audio Output Serial port PS/2 port ADB port 14 BNC Cable ✽ MAC Adapter Set slide switches according to chart below. VGA Cable DVI Cable ✽ USB Cable ✽ Audio Cable ✽ (stereo) Control Cable for Serial Port Terminal Control Cable for PS/2 Port Terminal Control Cable for ADB Port Terminal USB COMPUTER IN ANALOG COMPUTER IN DIGITAL COMPUTER AUDIO IN 1 or 2 ANALOG INPUT 1 DIGITAL(DVI-D) R/C JACK AUDIO 1 USB RESET CONTROL PORT AUDIO 2 G B R H/V V VIDEO/Y Cb/Pb Cr/Pr INPUT 2 VIDEO/Y Cb/Pb Cr/Pr R-AUDIO-L S-VIDEO (MONO) INPUT 3 Terminals of a Projector Use one of these Control Cables corresponding with terminal of your computer. CONTROL PORT ◆ MAC ADAPTER Set switches as shown in table below depending on RESOLU- ON TION MODE that you want to ON DIP use before you turn on projec- 123456 tor and computer. OFF 1 2 3 4 56 13" MODE (640 x 480) ON ON OFF OFF OFF OFF 16" MODE (832 x 624) OFF ON OFF ON OFF OFF 19" MODE (1024 x 768) OFF ON ON OFF OFF OFF 21" MODE (1152 x 870) ON ON ON ON OFF OFF NOTE : When connecting cable, power cords of both a projector and external equipment should be disconnected from AC outlet. Turn a projector and peripheral equipment on before computer is switched on.