Toshiba Tecra A2-S316 Maintenance Manual - Page 89
Procedure 2, Message Check, 5 HDD Troubleshooting, Troubleshooting Procedures, Replacement Procedures
View all Toshiba Tecra A2-S316 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 89 highlights
2.6 2.5" HDD Troubleshooting 2 Troubleshooting Procedures Procedure 2 Message Check When the power is turned on, the system performs the Initial Reliability Test (IRT) installed in the BIOS ROM. When the test detects an error, an error message is displayed on the screen. Make sure of no floppy disk in the FDD. Turn on the computer and check the message on the screen. When an OS starts from the 2.5" HDD, go to Procedure 3. Otherwise, start with Check 1 below and perform the other checks as instructed. Check 1 If any of the following messages appear, go to Procedure 3. If the following messages do not appear, perform Check 2. HDC ERROR or HDD #X ERROR (After 5 seconds this message will disappear.) Check 2 If either of the following messages appears, go to Check 3. If the following messages do not appear, perform Check 5. Insert system disk in drive Press any key when ready ..... or Non-System disk or disk error Replace and press any key when ready Check 3 Check SETUP to see whether the Hard Disk option is set to Not used. If it is set to Not used, choose another setting and return to Check 1. If it is not set to Not used, go to Check 4. Check 4 Using the SYS command of the MS-DOS, transfer the system to the 2.5" HDD. If the system is not transferred, go to Procedure 3. Refer to the MS-DOS Manual for detailed operation. If the following message appears on the display, the system program has been transferred to the HDD. System Transferred If an error message appears on the display, perform Check 5. Check 5 The 2.5" HDD and the connector of the system board may be disconnected (Refer to the steps described in Chapter 4, Replacement Procedures for disassembling.). Insert the connectors firmly. If they are firmly connected, go to Procedure 3. Satellite A50/TECRA A2 Maintenance Manual (960-478) 2-35