Toshiba Tecra S10 PTSB3C-0HQ09C Users Manual Canada; English - Page 170
Dynamic CPU Frequency Mode, Wake-up on LAN, Enabled, Dynamically, Switchable, Always High, Always Low
View all Toshiba Tecra S10 PTSB3C-0HQ09C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 170 highlights
HW Setup CPU This function allows you to set the processor's operating mode. Dynamic CPU Frequency Mode This option allows you to configure the power saving modes associated with the processor - the following settings are available: Dynamically Switchable The processor's power consumption and automatic clock speed switching functions are enabled - in use the processor's operation is automatically switched when necessary (default). Always High The processor's power consumption and automatic clock speed switching functions are disabled - in use the processor will always run at its highest level of power consumption and its highest speed. Always Low The processor's power consumption and automatic clock speed switching functions are disabled - in use the processor will always run at a lower level of power consumption and a low speed. LAN Wake-up on LAN This feature lets the computer's power be turned on when it receives a wake-up signal from the LAN. Do not install or remove a memory module while Wake-up on LAN is enabled. ■ The Wake-up on LAN function consumes power even when the system is off. Leave the AC adaptor connected while using this feature. ■ To enable it, you must check both the "Allow the device to wake the computer" and "Only allow management stations to wake the computer" check box within the "Intel Network Connection". Power will be automatically turned on when a signal is received from an administrator's computer which is connected via a network. The following settings can be changed when the Built-in LAN is Enabled. Connect the AC adaptor when using the Wake-up on LAN function. The battery retention time will be shorter than the times listed in this manual when this function is enabled. Refer to the section in chapter 6, Retaining data with power off. Enabled Disabled Enables Wake-up on LAN (Default). Disables Wake-up on LAN. User's Manual 7-6