Toshiba W704 Owners Manual - Page 39

RECORDING 6 Select "CONTROL" using PLAY/x2 or STOP, and set to "ON" or "OFF" using FF or REW. ON: if your DSS® satellite receiver is remote-controllable. • Satellite channels will be selected by CH (CABLE BOX) on the remote control. The VCR can change the satellite channel to the desired one when timer recording starts. → Go to step 7. OFF: if your DSS® satellite receiver is NON remote-controllable. • Satellite channels will be selected by the own channel selector of the DSS® satellite receiver. The VCR channel should be set to the output channel of the DSS® satellite receiver. → Go to step 8. PROGRAM SET UP PRESET USE nO C. BOX DSS OUTPUT CH 3 CH COn TROL BRAnD TYPE OFFnO . On 1 EnD: PROG PROGRAM SET UP PRESET USE nO C. BOX DSS OUTPUT CH 3 CH COn TROL OFF On EnD: PROG 7 Select "BRAND TYPE" using STOP, and enter a brand code of your DSS® satellite receiver using number buttons. Refer to the table on the next page. Example: For a TOSHIBA DSS® satellite receiver, identified by number 99. PROGRAM SET UP PRESET USE nO C. BOX DSS OUTPUT CH 3 CH COn TROL BRAnD TYPE OFFnO . On 99 VCR display EnD: PROG Make sure that the background of the above display has changed to the satellite program on channel 200. If not, relocate the DSS® satellite receiver on the VCR so that it can receive the infrared signal. 8 Press PROG. to exit. Notes • If your satellite channel does not change to 200 in step 7, the DSS® satetllite receiver will not be able to change channels in the timer recording. In this case, set "CONTROL" to "OFF" in step 6. • The VCR Plus+ C3 ® system recording is not available on satellite channels. • The DSS® satellite receiver control is not compatible with the cable box control. 39