Tripp Lite OMNISMART1400 Owner's Manual for OmniSmart SmartPro USB 932141 - Page 3

200306109 OmniSmart and SmartPro USB Owner's Manual.qxd 7/14/2003 4:56 PM Page 3 Quick Installation 1 Connect your UPS to an electrical outlet. Your UPS will run a self-test after it is plugged in. See Basic Operation to understand the results of its self-test. 2 Plug your computer, monitor and other equipment into 1 the UPS system. NORM DELAY Your UPS is designed to support only computer equipment. You will overload your UPS if you connect high power draw equipment such as household appliances or laser printers to outlets providing UPS battery backup. Select models feature special outlets (clearly labeled on the rear panel) which provide surge-only (not battery backup) protection designed for 2 laser printers and other heavy-draw devices. 3 Select UPS Operating Mode.* Press the ON/OFF button to toggle your UPS between the UPS (" " LED lit) and the CHARGE ONLY (" " LED flashing) modes. Choose the operating mode based on your location: USA, Canada & Western Europe: • Leave the UPS in the UPS mode at all times. All other countries: 3 • Put the UPS in the CHARGE ONLY mode when you are not using connected equipment. (WARNING! When set to "CHARGE ONLY," the UPS will not provide battery backup during a blackout or brownout) • Put the UPS in the UPS mode when you are using connected equipment. *See Basic Operation section for a complete explanation of each mode. 3