Tripp Lite OMNIVSINT800 Owner's Manual for OMNIVSINT800/OMNIVSINT1000/OMNIVSIN - Page 7
Telephone or Network Protection Jacks select models, External Battery Pack Connection select models
View all Tripp Lite OMNIVSINT800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Basic Operation continued NORM DELAY NORM DELAY Telephone or Network Protection Jacks (select models): These jacks protect your equipment against surges over a telephone or data line. Connecting your equipment to these jacks is optional. Your UPS will work properly without this connection. Not compatible with PoE (Power over Ethernet) applications. External Battery Pack Connection (select models): Ensure that the external batteries you are connecting match the voltage listed on your UPS's battery connector. Plug the battery connection cable (attached to the battery pack) into the UPS's External Battery Connector. Your UPS has internal batteries; external batteries are only needed to extend runtime. Adding external batteries will increase recharge time as well as runtime. Make sure that the end of the cable is fully inserted into the UPS connector. Several small sparks may result during battery connection; this is normal. USB Port: This port can connect your UPS to any computer for automatic file saves and unattended shutdown in the event of a power failure. Use with Tripp Lite's PowerAlert Software and appropriate USB cable. A PowerAlert CD and USB cable may be included with your UPS; if so, insert the CD into the CD tray of your computer and follow the installation instructions. If PowerAlert Software and the appropriate cable did not come with your UPS, you can download the software FREE via the Web at www.tripplite.com. Any user-supplied USB cable may then be used to connect the UPS to your computer. NOTE: This connection is optional. The UPS will work properly without this connection. Battery Replacement Door: Under normal conditions, the original battery in your UPS will last several years. Battery replacement should be performed only by qualified service personnel. Refer to "Battery Warnings" in the Safety section. Should your UPS require battery replacement, visit Tripp Lite on the Web at www.tripplite.com/support/battery/index.cfm to locate the specific replacement battery for your UPS. Power Sensitivity Adjustment: This dial is normally set fully counterclockwise, enabling the UPS to provide maximum protection against waveform distortions in its AC input. When such distortion occurs, the UPS will normally switch to providing PWM sine wave power from battery. In areas with poor utility power or where the UPS's input power comes from a backup generator, chronic waveform distortion could cause the UPS to switch to battery too frequently, draining the battery. You can reduce how often your UPS switches to battery due to moderate waveform distortion by experimenting with different settings for this dial. As the dial is turned clockwise, the UPS becomes more tolerant of variations in input power AC waveform. NOTE: The further the dial is adjusted clockwise, the more waveform distortion the UPS will pass to connected equipment. When experimenting with different settings for this dial, operate connected equipment in a safe test mode so that the effect on the equipment of any waveform distortions in the UPS's output can be evaluated without disrupting critical operations. 7 200908153 93-2205.indd 7 11/2/2009 1:17:19 PM