Tripp Lite SMART1000RM1U Owner's Manual for SmartPro Rackmount UPS 932406 - Page 4

200503166 93-2406 Sinewave SmartPro Rackmount UPS OM.qxd 3/29/2005 3:12 PM Page 4 Mounting (Rack) continued 2-Post (Telecom) Mounting Mount 1U UPS models in 2-post racks with included hardware following the procedure below. If you mount 2U UPS models in 2-post racks, they require the addition of a Tripp Lite 2-Post Rackmount Installation Kit (model: 2POSTRMKITWM, sold separately). See Installation Kit owner's manual for installation procedure for 2U UPS models. 1 Attach mounting ears A to the front mounting holes of your equipment B using the screws provided C . The ears should face backward. B C A 1 2 Using an assistant if necessary, lift your equipment and slide it onto the mounting shelves. Attach your equipment to the rack by passing the screws, nuts and washers provided D through its mounting ears and into the rack rails. D 2 Mounting (Tower) Mount all UPS models in an upright, tower position using included hardware. The user must determine the fitness of hardware and procedures before mounting. All UPS Models Stand your UPS on its side with the LED/Control panel at B the top. Attach one rack mounting ear A to each side of the UPS using included screws B . Attach the rack mounting ears to the floor with user-supplied hardware. A 2U UPS Models Only Rotate the LED/Control panel to view it easier while the UPS is tower mounted. Insert a small screwdriver, or other tool, in the slots on either side of the panel. Pop the panel out; rotate it; and pop the panel back in place. 4