Tripp Lite SRW10USG Owner's Manual for Swinging Wall-Mounted SmartRack&#17 - Page 4

5. Enclosure Configuration Before installation, be sure to plan the location and arrangement of components within the enclosure. Be sure all mounting rails are reversed or adjusted for depth, depending on your equipment configuration. 5.1 Door Locks The front and back doors have locks that are accessible by the included keys. Each side panel locks using an L-shaped lever on the inside of the enclosure. 1 To unlock and remove the side panels, lift the shorter leg of the "L" up A and pull it away from the side panel B . Pull the tab on the side panel and remove it from the enclosure. 2 To re-lock the side panels, secure it in the proper position, lift the shorter leg of the "L" up A and push it toward the side panel, back into the hole that it was in initially B . Once it is in place, push the shorter leg of the "L" down to lock it. Note: To lock and unlock the side panels, you will need to have access to the interior of the enclosure. A B A 1 5.2 Cable Access and Management The back door of the enclosure has a square opening for cable access and management. An additonal opening can be found on top of the main cabinet. Each opening can also be closed by screwing in the removable cable access panels. B 2 5.3 Reversing the Enclosure In order to accommodate various rack configurations, the enclosure can be reversed. To do so, simply turn the enclosure over so that the doors open in the opposite direction. 4