Troy-Bilt TB2BP Operation Manual - Page 1

ENGLISH - PAGE 2 TB2BP 2-Cycle Backpack Blower Operator's Manual Remove Unit From Carton Assemble The Unit Tools Required- Phillips Screwdriver T-20 Torx® Screwdriver 1 Remove all contents from the carton. Assemble The Unit 2 Place a hose clamp over the end of the Flex Tube and slide the end of the with the clamp on it over the elbow tube. Tighten the clamp screw. 40:1 3 Place a hose clamp over the other end of Flex Tube and slide the end over the top end of the upper blower tube. Tighten the clamp screw. 4 Insert the upper blower tube into the lower blower tube and twist the lower tube clockwise unit it locks into place. Start The Unit Primer Bulb 6 Loosen the 2 screws on the throttle control. Move the throttle control to the position that provides the best grip and tighten. 1 Gallon 3.2 oz 7 Mix thoroughly in separate fuel can: - 3.2 fl. oz. of 2-cycle engine oil - 1 gallon of unleaded gasoline NOTE: Do not mix directly in fuel tank. 8 Place unit on a level urface and fill fuel tank. DO NOT overfill. Start The Unit SLOW FAST 11 Press down cruise control to FAST position. 12 Crouch in starting position. 5 X 13 Pull rope 5 times. 9 10 X Press primer bulb 10 times, or until fuel is visible 14 Move choke lever to Position 2 . 5 Insert the lower blower tube into the nozzle and twist the nozzle clockwise until it locks into place. Zip tie the throttle cable to the elbow tube. Flex Tube On/ Off Switch Cruise Control Throttle Control Lower Blower Tube Nozzle Upper Blower Tube Spark Plug Starter Rope 10 Move choke lever to Position 1. Choke Lever Primer Bulb Fuel Cap DIDN'T START? Repeat these instructions. IF the engine hesitates, return the choke lever to Position 2 and continue the warm-up. IF the engine does not start, go back to step 9. IF the unit fails to start after 2 attempts, move choke lever to Position 3 and pull rope until unit starts 15 Pull rope 3-5 times to start engine. Keep the cruise control in FAST position and allow unit to warm up for 30 to 60 seconds. 16 Move choke lever to Position 3. SLOW FAST 17 Continue to keep the cruise control in FAST position and warm unit for an additional 60 seconds to complete warm-up. Unit may be used during this time. FRANÇAIS - PAGE 5 ESPAÑOL - PAGE 9 IMPORTANT: READ OPERATOR'S MANUAL THOROUGHLY AND FOLLOW THE SAFE OPERATION PRACTICES WHILE OPERATING THE UNIT. NEED HELP? Call 1-800-828-5500 in U.S. or 1-800-668-1238 in Canada 769-06202 P00 9/10