Troy-Bilt TB320 Operation Manual - Page 19
Problem, Cause, Remedy - mower blade
View all Troy-Bilt TB320 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
Problem Mower will not mulch grass Cause 1. Wet grass. 2. Excessively high grass. Uneven cut Mower will not self propel 3. Dull blade. 1. Wheels not positioned correctly. 2. Dull blade. 1. Belt not installed properly. 2. Debris clogging drive operation. 3. Damaged or worn belt. 4. Drive control out of adjustment. Remedy 1. Do not mow when grass is wet; wait until later to cut. 2. Mow once at a high cutting height, then mow again at desired height or make a narrower cutting path. 3. Sharpen or replace blade. 1. Place front and rear wheels in same height position. 2. Sharpen or replace blade. 1. Check belt for proper pulley installation and movement. 2. Stop engine, disconnect spark plug boot, and clean out debris. 3. Inspect and replace belt. 4. Adjust drive control. (See Assembly & Set-up section). Section 8 - Troubleshooting 19