Troy-Bilt TB350 Operation Manual - Page 12

3 Lower 2 Higher 1 Drive Control The adjustment wheel is located in the drive control handle housing and is used to tighten or loosen the drive belt. You will need to adjust the drive control if the mower does not propel itself with the drive control engaged or if the mower's wheels hesitate with the drive control engaged. If either of these conditions occur, rotate adjustment wheel clockwise to tighten cable or counterclockwise to loosen the cable. See Figure 3-13. High Wheel Figure 3-11 3. Release lever towards deck and place lever on one of the six height adjustment teeth. Handle Pitch For convenience of operation, you may adjust the pitch of the handle as follows: 1. Remove wing nuts and carriage bolts from handle. See Figure 3-12. Figure 3-12 2. Position the handle in one of the three positions that is most comfortable. See Figure 3-12 inset. 3. Secure into position with wing nuts and carriage bolts removed earlier. Loosen Tighten Figure 3-13 NOTE: For ease of adjustment, the speed control should be in the second or third speed. Set-Up Gas and Oil Fill-Up Refer to the separate engine owner's manual for additional engine information. 1. Add oil provided before starting unit for the first time out of the box. 2. Service the engine with gasoline as instructed in the separate engine owner's manual. WARNING: Use extreme care when handling gasoline. Gasoline is extremely flammable and the vapors are explosive. Never fuel the machine indoors or while the engine is hot or running. Extinguish cigarettes, cigars, pipes and other sources of ignition. 12 Section 3 - Assembly & Set-Up