URC DMS-1200 Owners Manual - Page 17

DMS-1200 SYSTEM CONFIGURATION System Configuration for Internal LAN Network Internet Cable Modem WiFi Router MFS-8 DVD PC DMS-1200 Follow the steps below to connect a DMS-1200 to a LAN network. 1. Connect the Internet to the coaxial CABLE port in the rear of the cable modem. 2. Plug in a RJ-45 ethernet connector cable via the Ethernet port of the cable modem to the WAN port of the Router. 3. Connect a second RJ-45 cable to a LAN port of the Router and plug the other end to the LAN 10/100 port on the rear of the MFS-8/MFSPOE-8 network Switch. 4. Connect a third RJ-45 cable to connect the DMS-1200 LAN port to one of the eight 10/100 Smart ports. 5. Plug the power supply to the DMS-1200 and then plug it in to an unswitched AC outlet. 6. Connect a digital coax cable from the DVD player to the coaxial digital input on the rear of the DMS-1200. 7. Connect a PC computer to the same LAN as the DMS-1200 or plug an ethernet cable directly to the LAN port of the DMS-1200. Now the computer can control and adjust the manufacturer's audio control program. l Select audio INPUT source and OUTPUT zone, MAC address etc. This function selects input source channel and INPUT gain level and data sent to audio equipment. l After selecting the output zone, adjust the zone limit power rate and zone power ON/OFF and source signal INPUT channel. l Adjust the amplifier volume level per each zone for proper sound output and maximum limitation volume level. l Turn on the ramp up volume level and adjust the equalizer repertory and low volume loudness control effectiveness and custom Equalizer align. Page 13