URC LT-3201-WH Owners Manual - Page 6

LT-3200 Switch LT-3200 Switch A C B D A. Config Button: This button is used to enter the configuration menu on your switch. When you hold it down for 10-15 seconds, the LED Bar (B) will light up Yellow to indicate you are in config mode. It can also be used to trigger a favorite scene. After setting up the scene, tap the button one time to trigger it. B. RGB LED Notification Bar: This LED bar serves as a visual display for whether your lights are on or off and offers visual notifications based on events that are setup via the Gateway. It can be further configured, disabling or setting certain brightness levels. C. Responsive Paddle: The paddle works in a similar manner to a standard switch. Pressing up will turn the light on while pressing down will turn the light off. The switch can be tapped up or down 1-5 times to trigger a specific scene. D. Air Gap Switch: This will cut the power to the load your switch is wired to. Including A Switch Below are the steps for including (pairing) a switch to a Gateway. Plan, Prep, and Install: • Locate an area to install the switch that is within a recommend distance from the Gateway. • Walls, ceilings, and even furniture may degrade communication between devices. • Remember to turn off the power prior to installation. • Check the signal range by holding the config button for 5-10 seconds. [ Green = Good Signal / Red = Poor Signal ] Including to the Network: • Put the Gateway into inclusion mode. • Once started, press the config button on the switch three times and the LED Bar will flash blue. If included successfully, the bar will turn green. If it turns red, the inclusion process failed. Switch Not Including? Try an Exclusion: • Put the Gateway into exclusion mode. • Once started, press the config button on the switch three times. The LED Bar will turn Green if excluded successfully. 6