URC PSX-1 Setup Guide

PSX Installation Manual (PSX-1 and PSX-2) ver. 1.1

1

NOTE: Use PSX Setup to update the

firmware of the PSX first (see page 6)!

Connecting the PSX for configuration:



When connecting this product to the end users Local Area Network, use a

standard 100 Base-TX base Ethernet hub / switch and a (Category 5 or

above) network cable.



Only use a crossover cable if connecting directly to a PC.



If this product has been used in or configured for another network, reset it to

the factory default settings before you start the configuration

; Press and

Hold the Reset button for ten seconds, then release.



If your PC is using the Windows XP embedded firewall or using the firewall

function of a third party security software such as Norton Internet Security,

“

disable the firewall function while configuring this product

”

.

Step 1 - Connect your PC to an Ethernet switch connected to the Local Area

Network.

Step 2 - Connect an Ethernet cable to the dock and the other end of the cable

to the Ethernet switch connected to the Local Area Network.

Step 3 - Connect the supplied AC Power Adapter to the PSX, then plug in the

AC end in

to an “Always

-

On” AC outlet.

Step 4 - Launch the PSXSetup software.

Configuring the PSX

Step 1

–

Run

“

PSX Setup

”

by clicking on the PSX module icon in the TOOLS menu

of CCP.