URC UR2-CBL-CV02 Owners Manual - Page 1

Operating Instructions For CABLEVISION Remote Control Universal Remote Control, Inc. www.universalremote.com OCE-0027A Rev 16(01/15/09) 1 Introduction The remote control is designed to operate Scientific-Atlanta Explorer 1850, 2000, 3000, 4200 and 4250HD Series set top boxes and the majority of TV's on the market. 3 Button Functions 2 Replacing Batteries Before you program or operate the remote control, you must install two AA alkaline batteries. STEP1 Remove the battery compartment cover on the back of your remote control. STEP2 Check battery polarity carefully, and install the batteries as shown in the illustration below. STEP3 Replace the battery compartment cover. STEP3 Point the remote control toward the TV and enter the three-digit code number assigned to your brand from the code tables. *Tip : The TV will turn off when the correct three-digit code number has been entered. You can verify you have selected the correct code by pressing the [MUTE] button, the TV should turn on or turn off. *Note : If there is more than one threedigit number listed for your brand, try one code number at a time until your TV turns off. STEP4 Store the three-digit code number by pressing the [TV] button once again. The iO button will blink twice to confirm that the code has been stored. *Note : Try all the functions on the remote control. If any of the functions do not work as they should, repeat from Step 2 using the next three-digit code number from the same brand list. 4 Operations Default State : Device Default: Scientific Atlanta Explorer 2000/3000 Volume Default : TV volume and mute through the TV, with the option of controlling volume and mute through the Cable. Refer to Section D for programming the volume and mute through your Cable. 5 Programming the Remote Control. A. Three-Digit Code Programming Method. The remote control can be programmed by pressing in a three digit code number that corresponds to particular manufacturers and brands of TV. The three-digit code numbers are listed in the code table of the instruction manual. STEP1 Turn on the TV you wish to program. STEP2 Press the [TV] button and the [SEL] button simultaneously for 3 seconds. The iO button will turn on indicating the unit is ready to be programmed. *Tip : TheiObuttonwilllightonfor20seconds.ThenextstepmustbeenteredwhiletheiObuttonison. www.universalremote.com B. Auto Search Method. If the three-digit code numbers assigned to your brand do not turn off your TV or the code tables do not list your brand, you can use the Auto Search Method to find the correct three-digit code number for your TV by the following steps: STEP1 Turn on the TV you wish to operate. STEP2 Press the [TV] button and the [SEL] button simultaneously for 3 seconds. The iO button will turn on. *Tip : The iO button will light on for 20 seconds. The next step must be entered while the iO button is on. STEP3 Press the [CH+] or [CH-] button one step at a time or keep it pressed. The remote will emit a series of Power ON/OFF commands. Release the [CH+] or [CH-] button as soon as the TV turns off. *Tip : You can verify that you selected the correct code by pressing the [MUTE] button. The TV should either turn on or turn off. STEP4 Press the [TV] button to store the code. The iO button will blink twice to confirm that the code has been stored.