URC URC-RFS200 Owners Manual - Page 19
Recalling Pre-Programmed Setup Code Numbers, Cloning Other RF20s
View all URC URC-RFS200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
35 Recalling Pre-Programmed Setup Code Numbers In case you didn't write down the Pre-Programmed Code Numbers that you used to set up your RF20, you can easily recall them using this simple process: 36 Cloning Other RF20s If you are fortunate enough to own more than one RF20, you'll be happy to know that you can easily copy and transfer all the setup from one RF20 to another. Just follow these easy steps: Recalling Pre-Programmed Setup Code Numbers Cloning Other RF20s CUSTOMIZING CUSTOMIZING STEP 1: Press and hold the MAIN and ENT (Enter) buttons at the same time for approximately 3 seconds, until the word "SETUP" is displayed at the top of the LCD touch screen. This signals that you are now in setup mode. IMPORTANT:You now have 30 seconds to perform the next step while you are in SETUP mode. If you don't press a button within 30 seconds, SETUP will disappear from the screen, signaling that you have exited setup mode and you will need to start over. STEP 2: Go to Page 2 of the Setup Menu by pressing the PAGE ( ) button. STEP 3: Press the RECAL display button on the LCD screen. The display will change to the Recall screens. The screen automatically switches between four screens, alternately flashing Page 1 components and code numbers, then Page 2 components and code numbers. STEP 4: Write down the code numbers as they appear for future reference. Page 43 of this manual provides a convenient space for you to record your code numbers. STEP 5: Return to normal operation by pressing the MAIN button twice. STEP 1: For both the programmed RF20 that you want to clone, and unprogrammed RF20, press and hold the MAIN and ENT (Enter) buttons at the same time for pproximately 3 seconds, until the word "SETUP" is displayed at the top of their respective LCD screens. This signals that both remotes are now in setup mode. IMPORTANT:You now have 30 seconds to perform the next step while you are in SETUP mode. If you don't press a button within 30 seconds, SETUP will disappear from the screen, signaling that you have exited setup mode and you will need to start over. STEP 2: Press a PAGE button on each remote to bring up Page 2 of Setup and display the CLONE button. STEP 3: Press the CLONE button on each remote. STEP 4: Align the two RF20s head-to- head, about an inch apart. STEP 5: Press the RECV display button on the unprogrammed RF20 that you want to setup by cloning. STEP 6: Press the SEND display button on the programmed RF20 that you want to clone. STEP 7: Press the START button on the unprogrammed RF20, and then press the START button on the programmed RF20 that you want to clone. NOTE: Cloning typically takes about 40 seconds. After successful cloning is completed, the newly cloned RF20 will flash "GOOD". STEP 8: Return to normal operation by pressing the MAIN button twice.