Uniden CAM945G Owners Manual - Page 11

Initial Setup

Get Uniden CAM945G PDF manuals and user guides View all Uniden CAM945G manuals
Add to My Manuals
Save this manual to your list of manuals

Page 11 highlights

or disconnect the device when leaving the vehicle to prevent draining the vehicle battery. Check your vehicle's owner's manual to determine if this applies to your vehicle. INITIAL SETUP Set Language Follow these procedures if you need to change the language on your device. 1. Press M to access the Menu system. 2. Press ▼ to scroll to System Configuration if necessary and then press (OK). 3. Press ▼ to scroll to Language then press . 4. Press ▲/▼to scroll to the desired language and press to select it. 5. Press M to leave that Menu page. Set Date and Time - CAM945 1. Press M to access the Menu system. 2. Press ▼to scroll to System Configuration and press . 3. Press ▼to scroll to Date/Time and press . 4. Use ▼/▲ to adjust the date and press to move to the next section. 5. Repeat Step 4 until the date is set. Press M to leave that Menu page. Set Date and Time - CAM945G/CAM945GT The CAM945G and CAM945GT receive date and time information from the GPS satellite if the time zone setting (UTC) is NOT set to OFF. If the UTC is set to OFF, the device will then recognize a manually-set date and time. 7

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
7
or disconnect the device when leaving the vehicle to prevent
draining the vehicle ba°ery. Check your vehicle’s owner’s manual to
determine if this applies to your vehicle.
INITIAL SETUP
Set Language
Follow these procedures if you need to change the language on your
device.
1.
Press
M
to access the Menu system.
2.
Press
▼
to scroll to
System Configuration
if necessary and
then press
(
OK)
.
3.
Press
▼
to scroll to
Language
then press
.
4.
Press
▲
/
▼
to scroll to the desired language and press
to
select it.
5.
Press
M
to leave that Menu page.
Set Date and Time - CAM945
1.
Press
M
to access the Menu system.
2.
Press
▼
to scroll to
System Configuration
and press
.
3.
Press
▼
to scroll to
Date/Time
and press
.
4.
Use
▼/▲
to adjust the date and press
to move to the next
sec±on.
5.
Repeat Step 4 un±l the date is set. Press
M
to leave that Menu
page.
Set Date and Time - CAM945G/CAM945GT
The CAM945G and CAM945GT receive date and ±me informa±on
from the GPS satellite if the ±me zone se³ng (UTC) is NOT set
to OFF. If the UTC is set to OFF, the device will then recognize a
manually-set date and ±me.