Uniden D1484 English Owner Manual - Page 13

Programming a Security Code With the phone in standby, open the menu; select Answering Setup, then select Security Code. Use the number keypad to enter a two-digit security code (01 to 99). Press Menu/select when you're finished. ## Remember to make a note of your new security code! Dialing In to Your System 1. Call your phone number from any touch-tone phone, and wait until the system answers. xxIf you have the Ring Time set to Toll Saver, the system answers after 2 rings if you have new messages and 4 rings if you don't. You can hang up during the third ring. xxIf the system is turned off, it answers after 10 rings and beeps sound. 2. During the greeting or beeps, press 0 and immediately enter your security code. If you enter it incorrectly 3 times, the system hangs up and returns to standby. 3. The system announces the time, the number of messages in memory, and a help prompt. It beeps to let you know it's waiting for a command; enter a 2-digit command from the chart. ## If you don't press any keys for 15 seconds, the system hangs up and return to standby. 01 Repeat message 02 Play message 03 Skip message 04 Delete message 05 Stop playback 06 Turn the system on 09 Turn the system off 10 Hear help prompts Important Information Troubleshooting General problems Possible solutions xxCheck the telephone cord connection. I can't make or receive xxDisconnect the base AC adapter. Wait a few calls. minutes, then reconnect it. xxMake sure the base is plugged in. The handset won't ring. xxMake sure the ringer is turned on. The handset is not working. xxCharge the battery for 15-20 hours. xxCheck the battery connection. The handset won't xxLet calls ring twice before answering. display CID information. xxMake sure your CID service is active. English - 13