Uniden DCT756-4 English Owners Manual - Page 49

Changing the Digital Security Code The digital security code is an identification code used to connect the handset and the base unit. Your unit ships from the manufacturer with a preset security code. Resetting this code is not normally necessary. In the rare situation that you suspect another cordless telephone is using the same security code or if you are instructed to change this code by a manufacturer's Call Center Representative, you can change the code. To change the digital security code: 1. Reset all handsets (see page 25). 2. Re-register each handset by following the steps on page 24. Traveling Out of Range During a call, as you begin to move your handset too far from your base unit, noise may increase. If you pass the range limits of the base unit, you hear a beep and see OUT OF RANGE on the display, and then the handset returns to standby. You may return to the call if you move your handset within the range limits of the base and press [ /flash] or [ ] within 30 seconds. Common Issues If your phone is not performing to your expectations, please try these simple steps first. If these steps do not solve your problem, please call our Customer Hotline (see back cover for contact information). Symptom The charge LED fails to light when the handset is placed in the cradle. The audio sounds weak. Suggestion • Make sure the AC adapter is plugged into the base or the charger (if you have more than one handset) and wall outlet. • Make sure the handset is properly seated in the cradle. • Make sure the charging contacts on the handset are clean. • Move the handset and/or base away from metal objects or appliances and try again. • Make sure you are not too far from the base. 49