Uniden DCX291 English Owner's Manual - Page 6

Compliance Information Any changes or modifications to this product not expressly approved by the manufacturer or other party responsible for compliance could void your authority to operate this product. FCC Part 15 information This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Privacy of communications may not be ensured when using this phone. FCC PART 15.105(b): Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: xxReorient or relocate the receiving antenna. xxIncrease the separation between the equipment and receiver. xxConnect the equipment into an outlet on a circuit different from that to which the receiver is connected. xxConsult the dealer or an experienced radio/TV technician for help. RF exposure Information This product complies with FCC radiation exposure limits under the following conditions: xxThe base must be placed to allow a minimum of 20 cm (8 inches) between the antenna and all persons during normal operation. xxThe base must not be collocated or operated in conjunction with any other antenna or transmitter. xxThe handset is designed for body-worn operation and meets FCC RF exposure guidelines when used with any belt clip, carrying case, or other accessory supplied with this product. (All necessary accessories are included in the package; any additional or optional accessories are not required for compliance with the guidelines.) Third party accessories (unless approved by the manufacturer) should be avoided as these might not comply with FCC RF exposure guidelines. 6 - English