TURN ON FLASHLIGHT
1.
Press
POWER
to turn on the LED flashlight in Steady mode.
2.
Press
POWER
again to cycle through the 4 modes: Steady, Slow
Strobe, Fast Strobe, and OFF.
MAINTENANCE
Use common sense when caring for your UPP120. Be sure the con
-
nectors and jacks remain clean and free of debris. Unplug the UPP120
after charging. Store the UPP120 and its accessories in the carrying
case provided.
TROUBLESHOOTING
IF...
TRY THIS...
My items are not recharging/
inflating.
•
Recharge the UPP120.
•
Verify that your items are connected
correctly.
I haven’t used my UPP120
in a while, and now the unit
is completely drained.
You may have accidently put it away
with it powered on. Recharge it.
SPECIFICATIONS
Battery
Size
1.6 in.x 3.1 in. x 7.0 in.
40 mm x 80 mm x 170 mm
Operating Temperature
–4
°
to + 140° F
– 20
°
to + 60
°
C)
Start Current
200A
Peak Current
400A
Capacity
44.4WH
Cycle life
1,000 times
Charge mode
CC/CV 15V 1A
USB output
5V 2A
AIR PUMP
Power Input
12V DC
Maximum Pressure
80 PSI
Maximum Current
4A
Unloaded Current
<2.5A
Inflating Speed
Less than 10 minutes to inflate tire from 0 to 30
PSI
Working Temperature
14
°
to 140
°
F (–10
°
~ +60
°
C)
Dimensions
10.8 X 9.5 X 4.7 cm
BATTERY DISPOSAL
The battery is self-contained and not consumer replaceable. The bat
-
tery must be disposed of properly when it no longer holds a charge.
Proper charging practices will increase the life of the unit. For informa
-
tion on battery recycling, call toll-free 800-822-8837.
FCC/INDUSTRY CANADA INFORMATION
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
Unauthorized changes or modifications to this equipment may void compliance with
the FCC Rules. Any change or modification must be approved in writing by Uniden.
Changes or modifications not approved by Uniden could void the user’s authority to
operate the equipment.
L’appareil est conforme aux normes d’Industrie Canada. Son fonctionnement
est soumis aux deux conditions suivantes : (1) Ce dispositif ne doit pas causer
d’interférences et (2), il doit pouvoir accepter les interférences, incluant celles
pouvant nuire à son fonctionnement normal.
Tous les changements apportés à cet appareil, s’ils ne sont pas expressément
approuvés par Uniden ou toute utilisation de celui-ci d’une autre manière que celle
décrite dans ce guide peut annuler votre autorisation de le faire fonctionner.
ONE-YEAR LIMITED WARRANTY
Important: Evidence of original purchase is required for warranty service.
WARRANTOR: Uniden America Corporation (“Uniden”) ELEMENTS OF WARRANTY:
-4-
-5-
1
2
3
4
