Vaddio AV Bridge MATRIX PRO AV Bridge MATRIX PRO Manual - Page 9
AV Bridge MATRIX PRO Rear Panel with Feature Call-outs
View all Vaddio AV Bridge MATRIX PRO manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
AV Bridge MATRIX PRO AV Bridge MATRIX PRO Rear Panel with Feature Call-outs: ① ② ③ ④ ⑤ 1. RS-232 Control Port Input: DE-9 female RS-232 communication port supporting Vaddio's serial command protocol from serial or third party controller (Pin 2 = TX, Pin 3 = RX, Pin 5 = GND). 2. Trigger Inputs: 10 contact closure (shunt to ground) inputs for triggering pre-programmed input video or audio selection, or to move cameras to preset locations. 3. Easy Mic Ports (Audio In 1-4): RJ-45 Type EasyMic ports allowing direct connection of up to 4 Vaddio MicPODs or Vaddio Ceiling Mic PODs. Any combination of MicPODs is acceptable. 4. Line Level Inputs (Audio In 5-8): Four Line level fully differential inputs for connection to balanced audio sources. Typical line level input reference levels of 0dBu. 5. Line Level Outputs (Audio Out 1-4): Four Line level fully differential outputs for connection to downstream balanced audio destinations such as in room amplification. Typical line level output reference levels of 0dBu. 6. Power Supply Input: 5.5mm OD x 2.5mm ID, center positive coaxial connector for supplying power to the device. Use only the 24 VDC, 3.75 Amp power supply provided with the AV Bridge MATRIX PRO. 7. Network IP Port: 10/100 Ethernet with embedded web server for configuration and management of the AV bridge. This port will stream H.264 and AAC audio, serve the browser pages, and provide Telnet control. 8. USB 2.0 Port: Type-B USB Port allows for USB interface to host computers and management of AV Bridge MATRIX PRO. This port will emulate a webcam and an audio record device, generating UAC and UVC files. 9. Camera RS-232 Control Ports (Camera Inputs 1-3): Self-configuring control ports for two Cat-5 cable based Vaddio camera systems. Handshakes with camera and sends camera controls as required. 10. Camera EZ Power/Video Ports (Camera Inputs 1-3): EZ Power video ports to provide power to the cameras and accept HSDS return differential component video for (2) CAT-5 cable based Vaddio cameras, at distances of up to 100' (30m) for PTZ cameras, and up to 150' (45m) for fixed POV cameras (ZoomSHOT or WideSHOT). PTZ Cameras 100' (30.48m) Cat-5e cable distance POV (fixed) cameras 150' (45.72m) Cat-5e cable distance AV Bridge MATRIX PRO Manual - Document Number 342-0915 Rev B Page 9 of 70