Vaddio PreVIEW Dual 6.4 LCD SD Rack Mount Monitor PreVIEW Dual 6.4 Monitor Man - Page 2
FCC Part 15 Compliance and CE Declaration of Conformity
View all Vaddio PreVIEW Dual 6.4 LCD SD Rack Mount Monitor manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
PreVIEW Dual 6.4 Intended Use: Before operating the Vaddio PreVIEW Series LCD Rack Mount Monitors, please read the documentation thoroughly. The systems were designed, built and tested for use indoors, and with the provided power supply. The use of a power supply other than the one provided or outdoor operation has not been tested and could damage the device and/or create a potentially unsafe operating condition. Save These Instructions: The information contained in this manual will help you install and operate your PreVIEW system. If these instructions are misplaced, Vaddio keeps copies of Specifications, Installation and User Guides and most pertinent product drawings for the Vaddio product line on the Vaddio website. These documents can be downloaded from www.vaddio.com free of charge. Important Safeguards: Read and understand all instructions before using. Do not operate any device if it has been dropped or damaged. In this case, a Vaddio technician must examine the product before operating. To reduce the risk of electric shock, do not immerse in water or other liquids and avoid extremely humid conditions and environments. The LCD panels are covered with a thin protective film. Remove this film by carefully lifting the film at a corner and carefully peel back. Do not scratch or apply pressure to the LCD surface. Scratched, cracked or broken LCD panels are not covered under warranty. Use all four screws when racking the PreVIEW series monitors. The tilting mechanism requires four screws for proper operation. The video inputs are 75 ohm and the looping outputs are active and require power to output the signal. Use only the power supply provided with the PreVIEW system. Use of any unauthorized power supply will void any and all warranties. FCC Part 15 Compliance and CE Declaration of Conformity FCC Part 15 Compliance This product is herewith confirmed and found to comply with the requirements set up by ANSI C63.4 & FCC PART 15 regulations for the evaluation of electromagnetic compatibility. This Device complies with Part 15 of the FCC rules Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) This device must accept any interference including interference that may cause undesired operation of the device. Standards: FCC Part 15:2005, Subpart B, Class B ANSI C63.4:2003 CISPR 22:1997+A1:2000+A2:2002 CISPR 16-1:2003 European Compliance This product meets the requirements for the below standards and hence fulfills the requirements of the EMC Directive 89/336/EEC as amended by Directives 92/31/EEC and 93/68/EEC within the CE Marking Requirement. Standard(s) To Which Conformity Is Declared: EN55022: 1998+A1:2000+A2:2003 Class B EN61000-3-2: 2000 EN61000-3-3: 1995+A1:2001 EN55024: 1998+A1:2001+A2:2003 IEC61000-4-2: 1995+A1:1998+A2: 2000 IEC61000-4-3: 2002 IEC61000-4-4: 2004 IEC61000-4-5: 1995+A1:2000 IEC61000-4-6: 1996+A1:2000 IEC61000-4-8: 1993+A1:2000 IEC61000-4-11: 1994+A1:2000 HARDWARE WARRANTY: Please see the Vaddio website at http://www.vaddio.com for the Vaddio Statement of Warranty for all Vaddio Products. The Statement of Warranty covers the policies and procedures of the Hardware Warranty, Exclusions, Customer Service, Technical Support, Return Material Authorizations (RMA), Voided Warranty, Shipping and Handling and Products Not Under Warranty. The Vaddio Warranty Statement supercedes all other published warranty statements in content and coverages. Vaddio Technical Support can be contacted through the Vaddio website or through e-mail support at mailto:[email protected]. Toll Free: 800-572-2011 ▪ Phone: 763-971-4400 ▪ FAX: 763-971-4464 www.vaddio.com ©2006 Vaddio - All Rights Reserved. Reproduction in whole or in part without written permission is prohibited. Specifications and pricing subject to change. Vaddio and PreVIEW are registered trademarks of Vaddio. Document 111506-64 Rev. B.