Vaddio Sony BRC-Z700 PTZ Camera Sony BRC-Z700 Operating Instructions - Page 23

Overview Hold down this button and press CAMERA button 1 to 7 to turn on/off the power of the camera corresponding to the pressed button. S CAMERA buttons Press one of the buttons to select the camera from among those connected. The selected CAMERA button lights in blue. T POSITION buttons You can store the various camera settings such as the pan, tilt and zoom positions to the memory of the camera corresponding to each POSITION button, and load the settings in the memory. Rear/Bottom MODE RS-232C VISCA RS-422 TALLY/CONTACT ! CONTACT(TALLY) TALLY 1 9 1 9 CONTACT DC IN 12V ON/OFF wa ws wd wf wg wh wj wk U MODE selector Select the position corresponding to the VISCAcontrollable camera to be connected. Switch position 0 1 2 3 4 5 6 7 Camera mode Automatically selected (default) BRC-300/300P EVI-D70/D70P EVI-D100/D100P EVI-D30/D30P SNC-RZ30N BRC-H700 BRC-Z700 Note Set the selector to position 7 when all the connected cameras are BRC-Z700s. For other connections, set the selector to position 0. V VISCA RS-232C connector Connect to the VISCA RS-232C IN connector of the camera or the BRU-H700 HD Optical Multiplex Unit. W VISCA RS-422 connector Connect to the VISCA RS-422 connector of the camera or the BRU-H700 HD Optical Multiplex Unit. An RS-422 connector plug is attached at the factory. X TALLY/CONTACT connector This connector is used for the tally lamp input or the contact output. Select the function of the connector using the TALLY/CONTACT selector. An RS-422 connector plug is attached at the factory. Y TALLY/CONTACT selector Select the function of the TALLY/CONTACT connector. TALLY: The tally lamp of the camera selected with the connected switcher lights. CONTACT: The contact output corresponding to the camera address selected with the Remote Control Unit is short-circuited against the connected switcher. CONTACT (TALLY): The contact output corresponding to the camera address selected with the Remote Control Unit is short-circuited against the connected switcher and the tally lamp of the camera selected with the connected switcher lights. Note Change the setting of the selector before you turn on the power of the Remote Control Unit. Otherwise, the setting is not effective. wh DC IN 12V connector Connect the supplied AC power adaptor. wj DIP switches (bottom) Switch 1 (RS-232C/RS-422 selector) Set to ON for RS-422, or OFF for RS-232C. Switch 2 (Communication baud rate selector) Set to ON for 38400bps, or OFF for 9600bps. Switch 3 (BRIGHT control function selector) Set to ON for IRIS and GAIN adjustments, or OFF for IRIS adjustment only. Note Set the DIP switches before you turn on the power of the Remote Control Unit. Otherwise, the setting is not effective. wk ON/OFF switch Press this switch to turn on/off the Remote Control Unit. 23 Location and Function of Parts