Vaddio Vaddio PowerVIEW HD-30 Vaddio PowerVIEW HD-22 and HD-30 Manual - Page 13

PowerVIEW HD-22 and HD-30 COMMUNICATION SPECIFICATION Communication Speed: 9600 bps (default) Start bit: 1 Stop bit: 1 Data bits: 8 Parity: None No Flow control 12345678 Pin # 1) 2) 3) 4) 5) 6) 7) 8) RJ-45 RS-232 and IR Out Pins Unused Unused Unused IR Output (Diff Signal to Quick-Connect SR) IR Ground (Diff Signal to Quick-Connect SR) GND (GND of IR Short Range - Pin 3) RXD (from TXD of control source) TXD (to RXD of control source) NOTE: The Vaddio PowerVIEW HD-22 and 30Control Protocol is similar, but not identical to, the Sony® VISCA™ command set in order to be compatible with several popular control devices. Not all VISCA commands are supported and there are many HD-22/30 specific commands in the following Command and Inquiry Lists. HD-22/30 Command List (1/2) Command Set Command Address Set Broadcast IF_Clear Broadcast Command Cancel CAM_Power On Off(Standby) CAM_Zoom Stop Tele(Standard) Wide(Standard) Tele(Variable) Wide(Variable) Direct CAM_Focus Stop Far(Standard) Near(Standard) Far(Variable) Near(Variable) AutoFocus ManualFocus Auto/Manual Direct CAM_WB Auto Indoor Outdoor One Push WB Manual Fluorescent One Push Trigger CAM_RGain Reset Up Down Direct CAM_BGain Reset Up Down Direct CAM_AE Full Auto Manual CAM_Iris Reset Up Down Direct CAM_Gain Reset Up Down Direct CAM_Backlight On Off CAM_Aperture Reset Up Down Direct Command Packet 88 30 01 FF 88 01 00 01 FF 8x 2p FF 8x 01 04 00 02 FF 8x 01 04 00 03 FF 8x 01 04 07 00 FF 8x 01 04 07 02 FF 8x 01 04 07 03 FF 8x 01 04 07 2p FF 8x 01 04 07 3p FF 8x 01 04 47 00 0p 0q 0r FF 8x 01 04 08 00 FF 8x 01 04 08 02 FF 8x 01 04 08 03 FF 8x 01 04 08 2p FF 8x 01 04 08 3p FF 8x 01 04 38 02 FF 8x 01 04 38 03 FF 8x 01 04 38 10 FF 8x 01 04 48 0p 0q 0r 0s FF 8x 01 04 35 00 FF 8x 01 04 35 01 FF 8x 01 04 35 02 FF 8x 01 04 35 03 FF 8x 01 04 35 05 FF 8x 01 04 35 06 FF 8x 01 04 10 05 FF 8x 01 04 03 00 FF 8x 01 04 03 02 FF 8x 01 04 03 03 FF 8x 01 04 43 00 00 0p 0q FF 8x 01 04 04 00 FF 8x 01 04 04 02 FF 8x 01 04 04 03 FF 8x 01 04 44 00 00 0p 0q FF 8x 01 04 39 00 FF 8x 01 04 39 03 FF 8x 01 04 0B 00 FF 8x 01 04 0B 02 FF 8x 01 04 0B 03 FF 8x 01 04 4B 00 00 0p 0q FF 8x 01 04 0C 00 FF 8x 01 04 0C 02 FF 8x 01 04 0C 03 FF 8x 01 04 4C 00 00 0p 0q FF 8x 01 04 33 02 FF 8x 01 04 33 03 FF 8x 01 04 02 00 FF 8x 01 04 02 02 FF 8x 01 04 02 03 FF 8x 01 04 42 00 00 0p 0q FF Comments Address Set (Daisy chain) IF Clear p:socket number(1,2) Power On/Off p:(1-Slow to 4-Fast) p:(1-Slow to 4-Fast) pqr: Zoom Position* p:(1-Slow to 4-Fast) p:(1-Slow to 4-Fast) pqrs: Focus position(0-0x438)* Normal Auto (Auto Tracing WB) Indoor Mode (Color Temp 3200K) Outdoor Mode (Color Temp 5600K) One Push White Balance Mode Manual White Balance Fluorescent(Color Temp 4200K) One Push WB Trigger pq:00-ff pq:00-ff Auto Exposure Mode Manual Control Mode pq(0x00-0xFF) pq(0x00-0xFF) pq(0x00-0x3F) *Zoom and Focus Data: CAM_Zoom: Range (0x000-0xA23/0xA73), HD22: 0xA23(22x Zoom), HD30: 0xA73(30x Zoom) CAM_Focus: Range (0x000-0x438) dependent on Zoom Position PowerVIEW HD-22 and HD-30 HD PTZ Cameras Document Number 342-0626 Rev A Page 13 of 16