ViewSonic G810 User Manual - Page 5
Quick Installation - driver
UPC - 766907386455
View all ViewSonic G810 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Quick Installation 1 Connect video cable Make sure both the monitor and computer are powered OFF. Connect the video cable to the computer, then to the monitor. Macintosh users: Models older than G3 require a Macintosh adapter. Attach the adapter to the computer and plug the video cable into the adapter. To order a ViewSonic® Macintosh adapter, contact ViewSonic. See Customer Support in this user guide. 2 Connect power cord Connect the power cord from the monitor to a properly grounded AC outlet. 3 Power-ON monitor and computer Power-ON the monitor, then power-ON the computer. This sequence (monitor before computer) is very important. NOTE: At this point Windows 98 users may receive a message asking them to install the G810 INF file. 4 Install INF and ICM files For CD-ROM: Insert your auto-start CD-ROM, select "Monitor Drivers," and follow the on-screen instructions. For diskette: Insert your diskette and run install.exe. Follow the on-screen instructions. 5 Windows users: Set the Timing Mode (resolution and refresh rate) Example: 1024 X 768 @ 75Hz. For instructions on changing the resolution and refresh rate, see the user guide for your computer's graphics card. Installation is complete. Enjoy your new G810 monitor! To be best prepared for any future customer service needs: Write the serial number (see back of the monitor) in "For your Records" on page 1 of this guide. Register the warranty of your monitor on the Internet at: www.viewsonic.com/registration/ AC Outlet Video Cable Power Cord ViewSonic G810 4