ViewSonic PJ1165 User Guide - Page 36

NETWORK Menu This projector provides the NETWORK function. If you use this function, please set up the projector according to the Network environment in which you use it. memo When you use a Network suitable to the DHCP function, the following operation is not required commonly, because the TURN ON is selected to the item "DHCP" at the shipment time. Please see the section "Network Setting Up". Item SETUP DHCP INFORMATION RESET Description Pressing the X (or the ENTER) button calls the IP ADDRESS menu. memo This item performs only when the TURN OFF is set to the item "DHCP" of this NETWORK menu. The IP Address is identification number of the projector on the Network. 1. Set the IP Address using the S/T buttons. memo The same number as the IP Address of other units cannot be used. Pressing the X (or the ENTER) button at the IP ADDRESS menu calls the SUBNET MASK menu. The SUBNET MASK is an address of the Network. 2. Set the same number as the address of the Network to be used. Pressing the X (or the ENTER) button at the SUBNET MASK menu calls the DEFAULT GATEWAY menu. The DEFAULT GATEWAY is the address of the main device. 3. Set the same number as the address of the device as gateway to an outer Network. Select the TURN ON or the TURN OFF using the S/T buttons. : TURN ON Ù TURN OFF When you use a Network unsuitable to the DHCP function, select the TURN OFF. Pressing the X (or the ENTER) button displays the INFORMATION menu. The INFORMATION menu shows the information about the current Network setting as illustrated below. Select the EXECUTE using the S button to reset the NETWORK menu items. : EXECUTE Õ CANCEL The items of the NETWORK menu are collectively returned to the initial setting. ViewSonic PJ1165 35