ViewSonic PJ513DB PJ513DB User Guide - Page 45

Warning message When the Lamp indicator lights up red or a message appears suggesting it is time to replace the lamp, please install a new lamp or consult your dealer. An old lamp may cause a malfunction in the projector and in some instances the lamp may explode. The Lamp indicator light and Temperature warning light will light up if the lamp becomes too hot. Turn the power off and let the projector cool for 45 minutes. If the Lamp or Temp indicator still lights up after turning the power back on, please contact your dealer. See "Indicators" on page 42 for details. The following Lamp warning displays will remind you to change the lamp. Message Notice Order Replacement Lamp Lamp > 2000 Hours OK Status The lamp has been in operation for 2000 hours. Install a new lamp for optimal performance. If the projector is normally run with "Economic Mode" selected (See "Lamp Mode (Normal)" on page 35), you may continue to operate the projector until the 2950 hour lamp warning appears. Notice Replace Lamp Soon Lamp > 2950 Hours The lamp has been in operation for 2950 hours. A new lamp should be fitted to avoid the inconvenience when the projector runs out of lamp time. OK Notice Replace Lamp Now Lamp > 3000 Hours Lamp usage time exceeded OK The lamp has been in operation for 3000 hours. It is strongly recommended that you replace the lamp at this age. The lamp is a consumable item. The lamp brightness diminishes with use. This is normal lamp behavior. You can replace the lamp whenever you notice that the brightness level has significantly diminished. If the lamp is not replaced beforehand, it must be replaced after 3000 hours usage. Notice Out of Lamp-Usage Time The lamp MUST be replaced before the projector will operate normally. Replace lamp (refer to User manual) Then reset lamp timer OK ViewSonic 39 PJ513D/PJ513DB