ViewSonic PJD7383i PJD7383, PJD7383I, PJD7583W, PJD7583WI User Guide (English) - Page 43
Controlling the projector through a LAN, environment
UPC - 766907455014
View all ViewSonic PJD7383i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
Controlling the projector through a LAN environment You can manage and control the projector from one or more remote computers when they are properly connected to the same local area network. Internet Cable/ADSL modem Wired LAN connection If you are in a DHCP environment: 1. Take a RJ45 cable and connect one end to the RJ45 LAN input jack of the projector and the other end to the RJ45 port on your Ethernet or router. 2. Press MENU/EXIT on the projector or Menu on the remote control and then press / until the SYSTEM SETUP: Basic menu is highlighted. 3. Press to highlight LAN Control Settings and press MODE/ENTER on the projector or ENTER on the remote control. The LAN Control Settings page is displayed. 4. Highlight Wired LAN and press MODE/ENTER on the projector or ENTER on the remote control. 5. Make sure the Status is Connect. 6. Press to highlight DHCP and press / to select On. 7. Press to highlight Apply and press MODE/ENTER on the projector or ENTER on the remote control. 8. Please wait for around 15 - 20 seconds, and then re-enter the Wired LAN page. The IP Address, Subnet Mask, Default Gateway, and DNS settings will be displayed. Note down the IP address displayed in the IP Address row. • If the Projector IP Address still does not appear, contact your network administrator. • If the RJ45 cables are not properly connected, the IP Address, Subnet Mask, Default Gateway, and DNS settings will display 0.0.0.0. Make sure the cables are properly connected and perform the procedures above again. • If you wish to connect to the projector in its standby mode, be sure you have selected RJ45 and obtained the IP Address, Subnet Mask, Default Gateway, and DNS information when the projector is on. If you are in a non-DHCP environment: 1. Repeat steps 1-5 above. 2. Press to highlight DHCP and press / to select Off. 3. Contact your ITS administrator for information on the IP Address, Subnet Mask, Default Gateway, and DNS settings. Operation 39