ViewSonic PJD7583wi PJD7383, PJD7383I, PJD7583W, PJD7583WI User Guide (English - Page 79
Troubleshooting
UPC - 766907511123
View all ViewSonic PJD7583wi manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 79 highlights
Troubleshooting The projector does not turn on. Cause There is no power from the power cord. Attempting to turn the projector on again during the cooling process. No picture Cause The video source is not turned on or connected correctly. The projector is not correctly connected to the input signal device. The input signal has not been correctly selected. The lens cover is still closed. Blurred image Cause The projection lens is not correctly focused. The projector and the screen are not aligned properly. The lens cover is still closed. Remote control does not work Cause The battery is out of power. There is an obstacle between the remote control and the projector. You are too far away from the projector. Remedy Plug the power cord into the AC inlet on the projector, and plug the power cord into the power outlet. If the power outlet has a switch, make sure that it is switched on. Wait until the cooling down process has completed. Remedy Turn the video source on and check that the signal cable is connected correctly. Check the connection. Select the correct input signal with the SOURCE key on the projector or remote control. Open the lens cover. Remedy Adjust the focus of the lens using the focus ring. Adjust the projection angle and direction as well as the height of the projector if necessary. Open the lens cover. Remedy Replace the battery with a new one. Remove the obstacle. Stand within 8 meters (26 feet) of the projector. Troubleshooting 75