ViewSonic PS600W - 3700 Lumens WXGA Networkable Short Throw Projector User Gui - Page 26
Operation, Starting up the projector
View all ViewSonic PS600W - 3700 Lumens WXGA Networkable Short Throw Projector manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
Operation Starting up the projector 1. Plug the power cord into the projector and into a wall socket. Turn on the wall socket switch (where fitted). 2. Press Power to start the projector. As soon as the lamp lights up, a "Power On Ring Tone" will be heard. The Power indicator light stays blue when the projector is on. (If necessary) Rotate the focus ring to adjust the image clearness. If the projector is still hot from previous activity, it will run the cooling fan for approximately 90 seconds before energizing the lamp. To maintain the lamp life, once you turn the projector on, wait at least 5 minutes before turning it off. To turn off the ring tone, see "Turning off the Power On/Off Ring Tone" on page 43 for details. 3. If the projector is activated for the first time, select your OSD language following the on-screen instructions. 4. Switch all of the connected equipment on. 5. The projector will start to search for input signals. The current input signal being scanned appears in the bottom right corner of the screen. If the projector doesn't detect a valid signal, the message 'No Signal' will continue to be displayed until an input signal is found. You can also press Source to select your desired input signal. See "Switching input signal" on page 25 for details. If the frequency/resolution of the input signal exceeds the projector's operating range, you will see the message 'Out of Range' displayed on a blank screen. Please change to an input signal which is compatible with the projector's resolution or set the input signal to a lower setting. See "Timing chart" on page 73 for details. 21